TM 9-2350-222-20-1-5
DRIVER'S HATCH MOUNT LID REPLACEMENT (M24 IR PERISCOPE) (Sheet 2 of 3)
CLEANING AND INSPECTION:
1.
Visually inspect all parts for cracks. All cracked parts must be replaced.
2.
Visually inspect all parts for mechanical damage or wear. All damaged or worn parts must be
replaced.
Visually inspect all parts for corrosion. Corroded parts which cannot be cleaned with crocus cloth
3.
4.
Using putty knife, remove paint and other debris from lid seal mounting surface.
5.
Clean mounting surface with clean cloth soaked in dry cleaning solvent (Item 54, Appendix D).
INSTALLATION:
NOTE
Minimum room temperature for bonding is 650F. Do not use
tape to hold parts in place.
1.
Apply thin coat of adhesive (Item 2, Appendix D) to lid seal groove.
2.
Allow adhesive to set for 15 minutes.
Join new lid seal (A) to groove in mount (B).
3.
TA253597