TM 9-2350-222-34-1
TRACK ADJUSTING LINK REPAIR (Sheet 6 of 13)
11. Using 7/16 inch socket, install safety relief valve
(L) in cylinder (M).
12. Using 7/16 inch socket, install grease fitting (N)
in yoke (P) of shaft assembly (Q).
13. Using 7/16 inch socket, install support (R) on
yoke (P) with two screws (S) and new
14. Apply a heavy coat of grease (Item 14, Appendix
B) to
inside of
cylinder (M) and to
shaft assembly
(Q).
15. Insert shaft assembly (Q) into cylinder (M) until
shaft assembly (Q) is fully seated in cylinder (M).
until nut (B) is seated against cylinder (M).
17. Using 3/4 inch socket, install locking screw (U) in
cylinder (M) to hold nut (B), but do not tighten
screw (U) fully.
Go on to Sheet 7
TA248771
Change 2 9-34