TM 9-2350-222-20-1-5
HYDRAULIC RESERVOIR TO SLIPRING TUBE ASSEMBLY REPLACEMENT
(Sheet 3 of 3)
INSTALLATION:
1.
Lubricate threads and sleeves with oil (Item 43,
2.
Install nut (A) onto elbow (B) by hand.
3.
Work new packing (C) onto elbow (B).
4.
Using 1-5/16 inch wrench, install elbow (B) into
reservoir connection up to packing (C). Seat
packing (C) into reservoir connection.
5.
By hand, turn nut (A) down onto packing (C)
and reservoir connection. Position elbow (B) in
down position. Using 1-5/8 inch wrench,
tighten nut (A).
6.
Position tube (D) onto elbow (E) and start nut
(F) onto elbow (E) by hand.
7.
Install upper end of tube (D) into elbow (B) and
start nut (G) by hand.
8.
Using 1-5/8 inch wrench to hold elbow (E) in
position and using 1-1/2 inch wrench on nut (F),
tighten nut (F) onto elbow (E).
9.
Using socket, install clamp (H) with screw and
new lockwasher (J) onto reservoir mount.
10.
Using 1-1/2 inch wrench on nut (G), tighten nut
(G) onto elbow (B).
11.
Close turret floor access cover.
12.
Refill hydraulic reservoir with oil (Item 43,
End of Task
TA141192
18-90