TM 9-2350-222-20-1-5
FRONT DRAIN VALVE ASSEMBLY REPLACEMENT (Sheet 1 of 5)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Cleaning and Inspection
Installation
Flat-tip screwdriver (2 required)
TOOLS: Prybar
6 or 12 in. ruler
1/2 in. socket with 1/2 in. drive
Putty knife
Ratchet with 1/2 in. drive
Slip joint pliers
Hand hammer
Vise
1/8 in. drive pin punch
Torque wrench with 1/2 in. drive
(0-175 lb ft) (0-237
Gasket (10663544
SUPPLIES:
Dry cleaning solvent (Item 54, Appendix D)
Rags (Item 65, Appendix D)
Lockwasher (MS35338-64) (4 required)
Locking compound (Item 16, Appendix D)
Hold cage (D) up when removing last screw (A). Valve
assembly may fall and cause injury.
1.
From underside of vehicle, using socket, remove four screws (A), lockwashers (3), and flat washers (C)
from cage (D). Throw lockwashers away.
Go on to Sheet 2
TA253632
