TM 9-2350-222-20-1-5
DRIVER'S ESCAPE HATCH REPAIR (Sheet 2 of 5)
2.
Using adjusting wrench to hold linkage (C), use
3/4 inch wrench and loosen two jamnuts (D).
3.
Using 5/8 inch wrench, remove screw (E)
securing linkage (C) to cover (B).
4.
Remove linkage (C) from cover (B).
5.
Using allen wrench, remove screw (F)
securing surface bolt (G) to linkage.
6.
Remove surface bolt (G).
7.
Using 3/4 inch wrench, remove two end
connectors (J) and jamnuts (D) from stud (H).
8.
Using hammer and punch, make a notch on
grooved pin (K) and on cover (B) for alinement
purposes during installation.
9.
Using hammer and punch, drive spring pin (L)
from handle assembly (M). Do not remove.
10.
Remove grooved pin (K) from handle assembly
(M) by pushing up from bottom.
Go on to Sheet 3
TA140748
16-136
