TM 9-2350-222-20-1-5
DRIVER'S ESCAPE HATCH REPAIR (Sheet 3 of 5)
1. Remove handle (N) assembly and two linkages
(P) from cover (B).
2. Using 5/8 inch wrench, remove two screws (Q)
separating handle assembly from two linkages.
CLEANING AND INSPECTION:
1.
Using rags, clean surface bolts and linkages of any excess dirt buildup.
2.
Clean seal groove and seal with dry cleaning solvent (Item 54, Appendix D) and coat with silicone
3.
Inspect all components for damage or wear. Replace as required.
ASSEMBLY:
1.
Plain two linkages (A) in position on handle
assembly (B).
2.
Using 5/8 inch wrench, install two screws (C)
securing linkages (A) to handle assembly (B).
3.
Place linkages and handle assembly (A) and (B)
in position on access cover (D).
Go on to Sheet 4
TA140749