TM 9-2350-222-20-1-5
DRIVER'S ESCAPE HATCH REPAIR (Sheet 4 of 5)
4.
Place two jamnuts (E) on stud (F).
5.
Place end connector (G) into surface bolt (H).
6.
Using allen wrench, install screw (J) in surface
bolt (H) securing end connector (G).
7.
Place end connector and surface bolt (G) and
(H) on one of studs (F).
8.
Place end connector (K) on other end of stud
(F).
9.
Using 3/4 inch wrench, tighten jamnuts (E)
up against both end connectors (G) and (K).
10. Install grooved pin (L) in position on cover (D).
11. Place complete linkage assembly (M) in position
on cover (D), notch on surface bolt (H) in down
position.
12. Using 5/8 inch wrench, install screw (N)
securing linkage (M) to cover (D).
Go on to Sheet 5
TA14075
16-138