TM 9-2350-222-20-1-5
DRIVER'S HATCH LOCKING MECHANISM REPLACEMENT (Sheet 7 of 7)
15. Using hammer, tap new cotter pin (P) into hole
in nut (N), through pawl (B) and secure.
16. Position plate spacers (Q) on locking mechanism
(R).
17. Aline screw holes in locking mechanism (R)
and plate spacers (Q) with holes in mounting
bracket.
18.
Place new lockwashers (S) and flat washers (T)
on two screws and insert screws (U) through
locking mechanism (R), spacers (Q), and into
bracket.
19.
Using 9/16 inch wrench, tighten screws (U).
Perform operational check of locking
20.
mechanism.
21.
Close driver's hatch (TM 9-2350-222-10).
TA140743
