TM 9-2350-222-20-1-5
DRIVER'S HATCH COVER ASSEMBLY REPLACEMENT (Sheet 4 of 4)
INSTALLATION:
1.
Using rag, clean both hull and hatch cover
sealing surfaces.
2.
Using two persons, place driver's hatch cover
(A) in position over hatch opening (B).
3.
Lower hatch cover (A) until driver's hatch
shaft (C) can be installed through driver's
hatch mechanism (D).
4.
Place hatch cover (A) in closed position, but
do not lock.
5.
Place left end housing (E) in position on end of
driver's hatch shaft (C).
6.
Using fingers, install four screws (F) and new
lockwashers (G). Do not tighten.
7.
Using shims (H), shim gap between hull roof
and left end housing (E).
8.
Place right end housing (J) in position on
driver's hatch shaft (C). -
9.
Using fingers, install four screws (K); new
lockwashers (L), and flat washers (M). Do
not tighten.
10.
Using shims (N), shim gap between hull roof
and mounting bracket of right end housing
(J).
11.
Using wrench, tighten four screws on right
end housing, then left end housing.
12. Wind torque on torsion bar (page 16-91, steps 18 thru 27).
13. Perform torsion bar adjustment (page 16-88).
14. Perform setscrew adjustment (page 16-94).
TA140711
