TM 9-2350-222-20-1-5
DRIVER'S HATCH COVER ASSEMBLY REPLACEMENT (Sheet 2 of 4)
REMOVAL:
1.
Using wrench, remove four screws (A), lockwashers (B), and flat washers (C) securing right end
housing (D) to hull roof. Throw lockwashers away.
Remove end housing (D) and anchor (E) from
2.
driver's hatch shaft (F).
NOTE
Shims (G) are located between
right end housing and hull roof
mounting brackets.
3.
Tag shims (G) RH to make sure they are
returned to proper position.
4.
Using wrench, loosen nut (H).
5.
Using screwdriver, loosen setscrew (J) and
nut (H).
6.
Using wrench, remove four screws (K) and
lockwashers (L) securing left end housing (M)
to hull roof. Throw lockwashers away.
7.
Remove left end housing (M) from driver's hatch shaft (F).
NOTE
Shims (N) are located between left end housing and hull roof
mounting bracket.
8.
Tag shims (N) LH to make sure they are returned to proper position.
Go on to Sheet 3
TA140709
