TM 9-2350-222-20-1-4
BRAKE CONTROL HOUSING REPAIR (Sheet 12 of 14)
31. Using 9/16 inch wrench on flats of control assembly (AF) and 15/16 inch wrench on nut (AE),
tighten nut.
32.
Using pliers, install new cotter pin (AK),
33.
Position two washers (AL) and spring (AM) on
control assembly (AF).
34.
Position lever assembly (U) on control assembly
(AF) and thread two nuts (AN) on control
assembly finger tight.
NOTE
D o not tighten nuts (AN), They
will be tightened during adjustment
procedure.
35.
Position lever assembly (U) in housing clevis
(AP) and, using pliers, insert pin (AQ).
Go on to Sheet 13
TA140387
13-81
