TM 9-2350-222-20.1-4
BRAKE CONTROL HOUSING REPAIR (Sheet 10 of 14)
17.
Using vise, press bearing (S) into lever (T).
18.
Position lever assembly (U) on pawl (V) and
start pin (W) through pawl and lever assembly,
Position in vise and press pin through.
19.
Place large loop of spring (X) over end of lever
assembly (U) and other loop over end of pawl
(v).
20.
Insert lever assembly (U) with its attached
parts through cutout in lever (Y).
NOTE
When
installing
lever (Y) in
housing assembly (C), make sure
alining mark (dot) on lever (Y) is in
line with wide slot in shaft (Z).
21.
Slide lever (Y) with its assembled parts on shaft
(z).
22.
Using retaining ring pliers, install snapring
(AA) in groove of shaft (Z)
Go on to Sheet 11
TA253438
Change 1 13.79
