TM 9-2350-222-20-1-4
BRAKE CONTROL HOUSING REPAIR (Sheet 8 of 14)
5.
Using rule, check that top surface of hex on
stud (F) (the one closest to brake shaft) stands
out beyond transmission cover surface.
RULE
NOTE
If hex of stud (F) (the one closest
to brake shaft) does not stand out
beyond
transmission
cover
surface, add shims (G). If shims
are added, an equal number should
be added to the other stud (F) (the
one farthest from brake shaft).
6.
Using rule, check that end surfaces of three
forward spacer nuts (E) are equal in height. If
they are not, add shims (H) as necessary
between spacer nuts (E) and housing assembly
(c).
`7.
Place shim (G) and new packing (J) on each
stud (F).
8.
Position new gasket (K) in groove of housing
assembly (C).
GO on to Sheet 9
TA140383
13-77
