TM 9-2350-222-20-1-4
BRAKE MASTER CYLINDER REPLACEMENT (Sheet 1 of 5)
PROCEDURE INDEX
PAGE
PROCEDURE
I
Removal
Inspection
Installation
1-1 /8 in. box end wrench
TOOLS:
1 in. combination box and open end wrench
13/16 in. combination box and open end wrench
11/16 in. combination box and open end wrench
3/8 in. combination box and open end wrench
9/32 in. combination box and open end wrench
9/16 in. socket with 1/2 in. drive
5 in. extension with 1/2 in. drive
Ratchet with 1/2 in. drive
3/4 in. combination box and open end wrench
10 in. pipe wrench
Screwdriver
Container (to catch brake fluid)
SUPPLIES:
Silicone brake fluid (Item 34, Appendix D)
Silicone compound (Item 32, Appendix D)
3/4 in. plastic plugs (2 required)
Gasket (5276834)
Lockwasher (MS35338-65) (4 required)
Gasket (AN901-5C (2 required)
TM 9-2350-222-10
REFERENCE:
Place shift lever in N (neutral) position (TM 9-2350-222- 10)
PRELIMINARY
PROCEDURES:
Block tracks (TM 9-2350-222-10)
NOTE
Clean all parts and general
area prior to removal.
REMOVAL:
1.
Using 1-1 /8 inch wrench, remove cap and
gasket (A) from master cylinder (B).
Throw gasket away.
Position container under brake switch (C)
2.
to catch brake fluid.
..
TA253429
Go on to Sheet 2
13.40 Change 1
