TM 9-2350-222-20-1-4
BRAKE PRESSURE GAGE AND RELATED PARTS REPLACEMENT (Sheet 4 of 4)
8.
Place washer (K) on reducer (L).
9.
Using 3/4 inch wrench on base of gage (M) and
13/ 16 inch wrench on reducer (L), tighten
reducer to gage.
10.
Using 11/16 inch wrench, tighten nut on
master cylinder end of tube assembly (D).
11.
Tighten nut at gage end of tube assembly (D)
finger tight.
12.
Fill master cylinder with hydraulic brake fluid
(Item 34, Appendix D).
13.
Position 13/ 16 inch wrench on reducer (L) and
11/16 inch wrench on tube assembly nut (D)
with gage (M) facing driver's position.
14.
Push brake pedal until fluid flows at tube
assembly nut (D), then tighten nut.
Bleed master cylinder (page 13-12).
15.
16.
Press (do not pump) brake pedal. Check that
gage indicates 800 to 1000 psi and that pedal is
firm, not spongy,
Place shift lever in P (park) position and
17.
remove blocks from track (TM 9-2350-222-10).
End of Task
TA140347
13-39
