TM 9-2350-222-20-1-4
BRAKE MASTER CYLINDER MOUNTING BRACKET AND PUSH ROD REPLACEMENT
(Sheet 6 of 7)
Position roller assembly (K) and two washers
7.
(L) in clevis (G).
Slide two bearings (M) along bearing cutouts of
8.
bracket (J) above and below clevis (G).
Aline holes in items (K) thru (M) and insert
9.
new pin (N) with its hole alined with the hole
in top bearing (M).
Using hammer and punch, drive pin (P)
10.
through top bearing (M) and pin (N).
11. Using lint-free cloth (Item 12, Appendix D) and
alcohol (Item 8, Appendix D), clean face and
flange of master cylinder of all dirt and grease.
Carefully position bracket (J) with holes alined
12.
with base.
Place new lockwasher (Q) on each of three
13.
screws (R) and tighten screws finger tight.
Using 9/16 inch wrench, tighten three screws
14.
(R).
Go on to Sheet 7
TA140342
13-34