TM 9-2350-222-20-1-4
BRAKE MASTER CYLINDER MOUNTING BRACKET AND PUSH ROD REPLACEMENT
(Sheet 5 of 7)
NOTE
Nut (E) and clevis (G) have left
hand threads.
Thread nut (E), new lockwasher (F), and clevis
2.
(G) on rod (D),
3.
Snug up nuts (A) and (E) on push rod (C) and
clevis (G) with ends of push rod and clevis
about 1-1/2 inches apart and hex of rod (D)
about centered.
NOTE
Nuts (A) and (E) will be tightened
during adjustment procedure.
4.
Apply adhesive (Item 2, Appendix D) to groove
of push rod (C) and edge of smaller hole of new
boot (H).
Slide boot (H) over push rod (C) with drain hole
5.
down and seat lip of boot in groove of push rod.
6.
Insert assembled items (A) thru (H) in bracket
(J).
Go on to Sheet 6
TA140341
13-33
