.
TM 9-2360-222-20-1-4
UNIVERSAL JOINT REPLACEMENT (Sheet 5 of 7)
CAUTION
Use rope capable of picking up and holding at least 92 pounds.
5.
Using rope and crowbar, position universal joint (B) into general position in vehicle.
6.
Insert alining punch through one screw hole (E) and into corresponding final drive adapter
assembly screw hole to aline universal joint.
NOTE
Turn final drive adapter assembly (F) left or right to install four
straws (E) and two new lockwires (G) (Item 59, Appendix D).
i'.
Aline three remaining screw holes (E) with final drive adapter assembly (F).
8.
Start threads of three screws (E) by hand.
9.
Remove alining punch from fourth screw hole.
10. Start threads of fourth screw (E) by hand.
Go on to Sheet 6
TA140307
12-15
