ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
FEMALE PLUG REPAIR (Sheet 2 of 3)
Using diagonal cutting pliers, cut wire from
contact (E). Throw away contact (E).
Pulling cut wire out of grommet (D), use
diagonal cutting pliers to shorten wire about 6
inches. Fasten new end of cut wire to cable (C)
with electrical tape (Item 58, Appendix D).
7. Using hand wire stripper, strip insulation
from jumper wire equal to depth of contact
8. Placing connector face down on flat surface,
apply a small amount of silicone (Item 32,
Appendix D) to empty holes on back of plug
assembly (B) and on front of grommet (D).
Push new contact (E) into hole in back of plug
assembly (B) far enough so it will remain
10. Push jumper wire end through grommet
retaining nut (A) and then through hole in
Go on to Sheet 3