ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
TERMINAL CONNECTOR REPAIR (Sheet 1 of 2)
TOOLS: Electrical connector repair tool kit
Diagonal cutting pliers
SUPPLIES: Heat-shrink tubing
PRELIMINARY PROCEDURES: Disconnect three battery ground straps (page 10-283)
Loosen or remove cable clamps as required
Using knife, slit heat-shrink tubing (A) along its
entire length. Throw heat-shrink tubing (A)
2. Using diagonal cutting pliers, cut terminal (B)
from cable (C). Throw terminal (B) away.
Using hand wire stripper, strip insulation from
cable (C) equal to well depth in terminal (B).
Go on to Sheet 2