TM 9-2350-222-20-1-4
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
MALE PLUG REPAIR (Sheet 3 of 3)
14. Using remover, push contact (E) into plug
assembly (B).
15. Sliding grommet (D) forward along cable (C),
set grommet (D) firmly against contacts (E).
16. Manually thread grommet retaining nut (A)
onto plug assembly (B).
17. Using multimeter, check continuity of repaired circuit.
18. Tighten or install cable clamps as required.
19. Connect connectors at each end of affected cable.
20. Connect three battery ground straps (page 10-283)
End of Task
TA139862
10-311
