TM 9-2350-222-20-1-3
ENGINE SHROUD REPAIR ON THE ENGINE (Sheet 3 of 5)
12.
Using screwdriver, remove six screws and
lockwashers (N) from retainer (P). Throw
lockwashers away.
Remove retainer (P) from shroud.
13.
Remove seal (Q) from shroud.
14.
15. Using 9/16 inch socket, remove six screws, washers, and lockwashers (R) holding access plate (S) to
right and left sides of shroud. Throw lockwashers away.
16. Remove access plate (S) with gasket from each
side of shroud.
17. Using putty knife, remove gasket from each
access plate (S). Throw gaskets away.
18. Using dry cleaning solvent (Item 54, Appendix
D) and rags (Item 65, Appendix D), clean areas
where gasket was removed.
ASSEMBLY:
1.
Using putty knife, apply adhesive (Item 4,
Appendix D) to back side of access plates (A).
2.
Install new gaskets (B) to access plates (A).
TA140245
Go on to Sheet 4
9-8
