TM 9-2350-222-20-1-3
ENGINE SHROUD SUPPORT REPLACEMENT (Sheet 2 of 2)
CLEANING AND INSPECTION:
1.
Inspect supports (A) and (B) insulation for wear,
tears, or loose areas.
2.
If required, use putty knife to remove
insulation from shroud supports.
Using dry cleaning solvent (Item 54, Appendix
3.
D) and rags (Item 65, Appendix D), clean areas
where insulation was removed.
INSTALLATION:
1.
If required, use putty knife to apply adhesive (Item 1, Appendix D) to shroud supports. Install new
insulation.
2.
Position front support (A) onto engine (B). Using wrench, install four washers, new lockwashers,
and screws (C) securing support (A) to engine (B).
3.
Position rear support (D) onto engine (B). Using wrench, install four washers, new lockwashers,
and screws (E) securing support (D) to engine (B).
4.
Install engine shroud (page 9-3).
5.
Install transmission shroud (page 9-23).
6.
Install top deck (page 16-23).
TA140242
End of Task
9-5
