TM9-2350-222-20-1-3
ACCELERATOR BULKHEAD FLANGE ASSEMBLY NUT REPLACEMENT (Sheet 4 of 4)
5.
Using fingers, turn jamnut (F) on rod assembly (C).
6.
Using 7/16 inch wrench, install rod end (G) on rod assembly (C). Turn rod end (G) until hole in
rod end (G) is alined with holes in clevis (H).
7.
Using 1/2 inch wrench, tighten jamnut (F) against rod end (G).
8.
Using hands, position rod end (G) in clevis (H) and aline holes.
9.
Install pin (J) through clevis (H) and rod end (G).
10. Using fingers, install new cotter pin (K) in pin
(J).
11. Using pliers, bend ends of cotter pin (K) around
pin (J).
12. Check adjustment of accelerator linkage (page
End of Task
TA149124
7-454
