TM 9-2350-222-20-1-3
ACCELERATOR BULKHEAD FLANGE ASSEMBLY NUT REPLACEMENT (Sheet 2 of 4)
REMOVAL:
1.
Using pliers, remove cotter pin (A) from pin (B). Throw cotter pin away.
2.
Using fingers, remove pin (B) from clevis (C)
and rod end (D).
3.
Using hand, separate clevis (C) from rod end
(D).
4.
Using 1/2 inch wrench, loosen jamnut (E) on
rod assembly (F).
5.
Using 7/16 inch wrench, remove rod end (D),
6.
Using allen wrench, remove two setscrews (G).
7.
Using 1-7/16 inch wrench, remove nut (H) and
washer (J).
8.
Slide nut (H) off end of rod asssembly (F).
Remove nut (H) from vehicle.
Go on to Sheet 3
TA149122
7-452
---