TM9-2360-222-20-1-3
ACCELERATOR BULKHEAD FLANGE ASSEMBLY NUT REPAIR (Sheet 2 of 2)
CLEANING AND INSPECTION:
1.
Using clean rags and dry cleaning solvent
clean bushing (A), nut (B), and fitting
thoroughly.
2.
Check bushing (A), nut (B), and fitting for
damage or wear. Replace if required.
ASSEMBLY:
Position new bushing (A) in end of nut (B).
1.
Place nut (B) and bushing (A) in vise.
2.
Tighten vise against bushing (A) and nut
3.
(B) until bushing (A) is fully inserted in
nut (B).
4.
Remove nut (B) from vise.
Using old bushing or hammer and punch,
5.
insert bushing 1/2 inch into nut as shown.
6.
Using fingers, press new seals (C) into ends of
nut (B). Install seals (C) with lips outward.
7.
Using wrench, install fitting (D) on nut (B).
8.
TA253321
End of Task
7-456 Change 1