TM9-2360-222-20-1-3
ACCELERATOR BULKHEAD FLANGE ASSEMBLY NUT REPLACEMENT (Sheet 3 of 4)
CLEANING AND INSPECTION:
1.
Using rags (Item 65; Appendix D), clean nut.
2.
Inspect grease fitting and seal for damage. Replace any damaged parts.
INSTALLATION:
1.
Install washer (A) and nut (B) on rod aasembly
(C).
2.
Using 1-7/16 inch wrench, tighten nut (B).
3.
Check that grease fitting (D) is in uppermost
hole in nut (B). If not, use 3/8 inch wrench and
move grease fitting to uppermost hole.
4.
Using allen wrench, install two setscrews (E) in
nut (B).
Go on to Sheet 4
TA149123
7-453
