TM 9-2350-222-20-1-3
THERMOSTATIC ENGINE OIL COOLER VALVE ASSEMBLY (LEFT AND RIGHT)
REPLACEMENT (Sheet 4 of 4)
INSTALLATION:
NOTE
If replacing valve assembly, the engine oil cooler bypass valve
also must be replaced. Go to page 6-13 or 6-15 for replace-
ment.
WARNING
Compressed air used for cleaning purposes will
not exceed 30 PSI. Use only with effective chip
guarding and personal protective equipment
(goggles/shield, gloves, etc.).
1.
Using low-pressure compressed air, dry valve.
Install new gasket (B) on valve (A).
2.
Seat threads of valve (A) in engine oil
3.
cooler socket (C) by hand.
4.
Using wrench, tighten valve (A).
Install left engine oil cooler (page 6-133)
5.
(if required).
6.
Connect engine oil return hose to fitting (page 6-134, step 14).
Tighten engine oil drain valve (page 6-135, step 16).
7.
Install engine oil filter vent bolt (page 6-135, steps 17 and 18).
8.
9.
Check engine oil level indicator gage rod (TM 9-2350-222-10).
10.
Replenish lubricating oil lost during valve assembly replacement.
11.
Using ground hop kit, perform ground hop test (page 5-48).
12.
Install powerplant (page 5-37).
End of Task
All data on pages 6-164 thru 6-166 deleted.
Change 4
6-163/(6-164 blank)
