TM 9-2350-222-20-1-3
THERMOSTATIC TRANSMISSION OIL COOLER VALVE ASSEMBLY (RIGHT SIDE)
TEST AND REPLACEMENT (2D ENGINE) (Sheet 5 of 7)
4.
Place valve in boiling water. Let free end of wire hang over edge of container.
5.
After about 30 seconds, use free end of wire to take valve out of water.
6.
Using ruler, measure overall length of valve. Record length.
7.
Compare length of valve before and after heating. If valve length increased less than 1/4 inch,
throw valve away. Obtain new valve and repeat test. If new valve passes test, install it.
WARNING
Compressed air used for cleaning purposes will not exceed 30
psi.
Use only with effective chip guarding and personal
protective equipment (goggles/shield, gloves, etc.).
8.
Using low-pressure compressed air, dry good valve.
INSTALLATION:
1.
Install new spacer ring (A) on valve (B).
2.
Using hands, install valve (B) to transmission
oil cooler.
3.
Using automotive wrench, tighten valve (B).
4.
Using 1-5/8 inch wrench, install inside
adapter (C).
5.
Using hands, install tube end fitting (D) on
adapter (C).
6.
Go to other end of tube (E).
Go on to Sheet 6
TA139538
6-171
