TM 9-2350-222-20-1-3
ENGINE OIL COOLER REPLACEMENT (2D ENGINE) (Sheet 1 of 6)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
6-130
Installation
TOOLS: Torque wrench with 3/8 in. drive (0-200 lb-in) (0-23 N-m)
3/4 in. socket with 3/8 in. drive
1/2 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
5 in. extension with 1/2 in. drive
1/2 in. combination box and open end wrench
3/4 in. combination box and open end wrench
1-1/2 in. open end wrench
(LEFT SIDE SHOWN,
RIGHT SIDE SIMILAR)
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
SUPPLIES: Washer (NAS1598-6V)
Drip pan
Masking tape (Item 57,
Appendix D)
Plastic barrier material
(Item 41, Appendix D)
Lockwasher (MS35338-43) (4 required)
REFERENCES:
TM 9-2350-222-10
PRELIMINARY PROCEDURES:
Remove powerplant (page 5-25)
Remove engine shroud (page 9-2)
REMOVAL:
1.
Using 1/2 inch socket, remove screw and
washer (A). Throw washer away.
2.
Using 3/4 inch wrench, loosen valve (B) six
complete turns.
Go on to Sheet 2
TA139499
6-130
