TM 9-2350-222-20-1-4
FINAL DRIVE ADAPTER ASSEMBLY AND OIL SEAL REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Position seal (A) in vehicle.
2.
Make sure rubber lip of seal (A) is toward
inside of hull.
Using hammer (B) and block of wood (C), tap
3.
seal (A) into place.
NOTE
Seal is seated when tapped in as
far as it will go.
4.
Make sure all sand, grit, and accumulated
debris has been removed from the final drive
adapter assembly (D).
5.
Apply grease (Item 37, Appendix D) inside
final drive adapter assembly (D) and on final
drive assembly spline (E).
6.
Using oil (Item 43, Appendix D), lightly coat
outside surface of final drive adapter
assembly (D).
7.
Alining internal splines in final drive
adapter assembly (D) with splines on input
shaft, slide final drive adapter assembly (D)
onto input shaft and into seal (A).
8.
End of Task
TA140303
12-10