TM 9-2350-222-20-1-4
INSPECTION AND REPAIR OF PIVOT PIN
NOTE
A modified center punch with a rounded point must be used to
properly stake pin in place.
Stake marks should be on the brass and deep and wide enough
to move brass over the pin.
Dispose of ring assembly in accordance with AR 756-2 or as di-
rected by local authority.
1. Grind sharp point of center punch (A) to
1/16 radius.
NOTE
Stake marks must be on brass.
2. Make sure pin(B) is securely staked in
place 3/32 inch minimum diameter, four
places equally spaced both sides. If staked
on pin (B), restake on brass in four places
between stake marks on pin (B). If chamfer
on brass is so large that metal does not
"mushroom" out over pin when staked, dis-
card ring assembly.
INSTALLATION OF COUPLING BOTH SIDES
12-8.6 Change 4