TM 9-2350-222-20-1-4
SHIFTING CONTROL BRACKET ASSEMBLY AND CONNECTING LINK REPLACEMENT
(Sheet 2 of 3)
4.
Using 3/4 inch wrench, tighten nut (G) against nut (F).
5.
Using 3/4 inch wrench, remove nut (H) and lockwasher (J). Throw lockwasher away.
NOTE
If stud (K) cannot be screwed in far enough in step 6, back off
nuts (G) and (F) on stud (K) and repeat step 6.
6.
Using 3/4 inch wrench, tighten nut (F) and screw stud (K) into transmission housing until stud (K) is
out of hole in bracket assembly (C).
7.
Remove bracket assembly (C) and lockwashers (L) from transmission. Throw lockwashers away.
Go on to Sheet 3
TA253387
Change 1
11-43