TM 9-2350-222-20- 1-4
SHIFTING CONTROL ROD AND LEVERS REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
1.
Position lever (A) on connecting shaft (B). Using hammer and punch, install new spring pin (C)
through lever (A) and shaft (B).
2.
Using 9/16 inch wrench, install jamnut (D) onto rod (E).
3.
Install rod end (F) onto rod (E) past witness holes.
4.
Position rod end (F) into clevis of lever (A). Using 9/16 inch wrench, install bolt (G) through clevis
of lever (A) and rod end (F),
NOTE
Make sure that clevis opening
on lever (H) is alined with spline
on transmission stud (J) before
installing lever (H).
5.
Install lever (H) onto transmission shaft stud
(J). Using hand, install screw (K) through
lever (H).
6.
Using 7/16 inch wrench, install screw (L) and
jamnut (M) into lever (H).
7.
Install new lockwasher (N) and nut (P) onto
screw (K). Using 9/16 inch wrench, tighten
nut (P).
8.
Using 9/16 inch wrench, install washer and
nut (Q) onto transmission shaft stud (J).
9.
Using pliers, install new cotter pin (R)
through nut (Q) and transmission shaft stud
Go on to Sheet 4
(J).
TA139300
11-47
