TM 9-2350-222-20-1-4
SHIFTING CONTROL ROD AND LEVERS REPLACEMENT (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS: Hammer
1/8 in. drive punch
Slip joint pliers
7/16 in. combination box and open end wrench
9/16 in. combination box and open end wrench
Flat-tip screwdriver
SUPPLIES: Spring pin (MS39086-161)
Cotter pin (MS24665-283)
Lockwasher (MS35338-65)
REFERENCE: TM 9-2350-222-10
PRELIMINARY PROCEDURES:
Block track and place shift lever in reverse (TM 9-2350-222-10)
Remove top deck (page 16-21)
Remove transmission shroud (page 9-20)
REMOVAL:
1.
Using pliers, remove cotter pin (A) from
transmission shaft stud (B).
2.
Using 9/16 inch wrench, remove nut and
washer (C) from transmission shaft stud (B).
Go on to Sheet 2
