TM 9-2350-222-20-1-3
CYLINDER HEAD AND OIL PAN DRAIN TUBES (LEFT AND RIGHT) REPLACEMENT
(Sheet 1 of 4)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Inspection
Installation
TOOLS:
7/8 in. socket with 1/2 in. drive
Flat-tip screwdriver
1/2 in. socket with 1/2 in. drive
Diagonal cutting pliers
Slip joint pliers
3/8 in. combination box and open end wrench
SUPPLIES: Lockwire (Item 59, Appendix D)
Gasket (8682772)
Lockwasher (7410210) (2 required)
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
REFERENCE: LO 9-2350-222-12
PRELIMINARY PROCEDURES:
Remove left oil cooler frame and brackets (2A engine,
Remove right oil cooler frame and bracket (2A engine,
REMOVAL:
U s i n g 1/2 inch socket, remove two bolts
1.
Remove gasket (B) and throw away.
2.
TA139422
Go on to Sheet 2
6-54