TM 9-2350-222-20-1-3
DRAIN ENGINE OIL (2D ENGINE) (Sheet 3 of 3)
10. Using 3/4 inch socket, tighten oil drain valve
(K).
11.
Using torque wrench, tighten oil drain valve
(K) to 150 lb-in (17 Nm).
12.
Using 9/16 inch socket with extension,
install vent bolt (H) and new sealing washer
(J).
13.
Refill crank case (LO 9-2350-222-12).
14.
Install upper engine access cover (page 16-40).
15.
Line up four holes in valve seat (A), new gasket
(E), and hull floor (C) under vehicle.
16. Using 3/4 inch socket, install four screws (B)
and new gasket (E) to hull floor (C).
17. Operate rear drain valve to make sure valve
opens and closes smoothly. If valve does not
open or close properly, remove, inspect, and
install valve assembly again.
End of Task
TA139421
6-53