TM 9-2350-222-34-1
ACCELERATOR CONTROL LINKAGE ASSEMBLY REPAIR (Sheet 9 of 13)
ASSEMBLY:
1.
Using socket head screw key, install drain plug (A)
into control housing (B).
2.
Push housing (C) with two bearings (D) onto clevis
with shaft (E). Line up scribe marks on housing (C)
and clevis with shaft (E).
3.
Using hammer, install new woodruff key (F) into
clevis with shaft (E).
4.
Push rod end clevis (G) onto clevis with shaft (E).
Line up reference marks on housing (C) and clevis
rod end (G).
5.
Using 7/16 inch wrench, install bolt and lockwasher
(H) into rod end clevis (G).
6.
Assemble clevis with shaft (E), two bearings (D),
housing (C), and rod end clevis (G) and install into
lower housing (B) as lever assembly (J).
Go on to Sheet 10
TA130575
4-119
