TM 9-2350-222-34-1
ACCELERATOR CONTROL LINKAGE ASSEMBLY REPAIR (Sheet 6 of 13)
CLEANING:
NOTE
When cleaning linkage assembly components, make sure scribe marks made
during disassembly are maintained for reference during assembly.
Wearing rubber gloves and using dry cleaning solvent
assembly components.
INSPECTION AND REPAIR:
1.
Check all linkage assembly bushing-type bearings.
2.
Check and repair all linkage assembly cast parts and mechanical surfaces.
3.
Visually check all linkage assembly tubes for distortion or bends. Replace any defective tube.
4.
Visually check all linkage assembly shafts, and levers, for elongated or cracked pin holes. Replace any defective
part.
5.
Check all linkage assembly rod end bearings for free movement, nicks, and burrs. Replace any rod end with nicks or
burrs which cannot be removed with a fine stone, or if free movement is impaired.
Go on to Sheet 7
4-116