TM 9-2350-222-34-1
ACCELERATOR TUBE ASSEMBLY REPAIR (RISER) (Sheet 2 of 2)
ASSEMBLY:
CAUTION
Do not apply excessive pressure with vise
which might bend tube.
1. Place tube assembly (A) in vise. Tighten vise.
2. Using wrench, tighten rod end (B) on tube (A) to
dimension shown.
3. Insert 5/64 inch drill bit in existing hole in rod end
(B) and drill through tube (A).
4. Using hammer and punch, install pin (C) in hole in
rod end bearing (B) and tube assembly (A).
5. Using wrench and 6 inch rule, tighten rod end (D)
on tube (A) to dimension shown, between centers
of rod ends (B) and (D).
NOTE
Make sure rod ends are parallel before
(A).
6. Insert 5/64 inch drill bit in existing hole in rod end
(D) and drill through tube (A).
7. Using hammer and punch, install pin (E).
TA130568
End of Task
4-110