TM 9-2350-222-34-1
ACCELERATOR TUBE ASSEMBLY REPAIR (Lower) (Sheet 2 of 2)
ASSEMBLY:
1. Position shoulder pin (A) in tube (B) with holes
alined.
2. Using hammer and punch, install pin (C).
CAUTION
Do not apply excessive pressure with vise
which might bend tube.
3. Place tube (B) in vise.
4. Using wrench and 6 inch rule, install rod end (D) on
tube (B) to the dimension shown below.
5. Insert 5/64 inch drill bit in existing hole in rod end (D)
and drill through tube (B).
6. Using hammer and punch, install pin (E).
7. Install tube assembly (page 4-105).
End of Task
TA130566
4-108
