TM 9-2350-222-20-1-5
FIXED FIRE EXTINGUISHER CYLINDER REPLACEMENT (LATE MODEL) (Sheet 1 of 3)
TOOLS:
1-5/8 in. open end wrench
Scales, 0-50 lb.
PRELIMINARY PROCEDURE:
Remove control valve (page 21-37)
WARNING
Handle charged cylinders with care. Do not jar or subject
cylinder to temperature above 140 degrees F (60 degrees C).
REMOVAL:
1.
Using wrench, disconnect discharge line
(A) from 1st shot cylinder (B) and two 2nd
shot cylinders (C).
Diffuser cap (C.1) must be
installed whenever the dis-
charge port is disconnected.
Failure to do so could result
in injury if cylinder is acci-
dentally discharged.
1.1. Install diffuser caps (C.1) on discharger
ports of cylinders (B) and (C).
Release strap (D) holding 1st shot fixed
2.
fire extinguisher cylinder (B) by grasping
latch (E) and pulling toward right side of
vehicle.
3.
Carefully remove 1st shot cylinder (B)
from bracket (F).
4.
Release strap (G) holding two 2nd shot
fixed fire extinguisher cylinders (C) by
grasping latch (H) and pulling toward
front of vehicle.
5.
Carefully remove cylinders (C) from
bracket (J).
Go on to Sheet 2
Change 4
