TM 9-2350-222-20-1-5
CONTROL VALVE ASSEMBLY REPAIR (Sheet 1 of 1)
TOOLS: Bench vise with brass jaws
8 in. adjustable wrench
SUPPLIES: Plug (11674311)
PRELIMINARY PROCEDURE:
DISASSEMBLY:
Secure control valve in vise with vent plug (A)
1.
up.
Using wrench, remove vent plug (A) from valve
2.
(B).
3.
Holding hand over hole where plug (A) was
removed, remove valve (B) from vise. Turn
plug hole down and remove ball (C) from valve
(B).
INSPECTION:
Inspect plug hole and ball (C) for nicks and
burrs. If damaged, replace damaged part.
ASSEMBLY:
1.
Secure valve (B) in vise with hole up.
2.
Place ball bearing (C) in hole in valve (B).
3.
Using wrench, install new plug (A) into valve
(B).
4.
Remove valve (B) from vise.
End of Task
TA140951