TM 9-2350-222-20-1-5
CONTROL VALVE ASSEMBLY REPLACEMENT (Sheet 2 of 12)
REMOVAL AND DISASSEMBLY:
CAUTION
To prevent accidental discharge of a cylinder, both control
valves must be removed from cylinders aven though only one
of the control valves must be replaced. Do not pull on the
control cable while valve is being removed, or cylinder will
discharge.
1.
Using 7/16 inch wrench to hold adapter
(A), use 9/16 inch wrench and loosen and
remove connector on tube (B) from adapter
(A). Remove adapter (A).
NOTE
It may be necessary to loosen
straps holding cylinders (C) and
(D) to perform step 2.
CAUTION
Loosan straps only if tube (B)
cannot be removed with straps
When straps are
tightened.
loosened, the chance of acciden-
tally discharging cylinders while
performing this procedure is
increased.
If necessary, loosen strap securing cylin-
2.
ders (C) and (D) and move top of cylinder
(D) forward. Using 9/16 inch wrench,
loosen connector on tube (B) from elbow
(E). Remove tube (B).
Go on to Sheet 3
Change 4
