TM 9-2350-222-20-1-5
EXTERIOR RELEASE HANDLE MOUNTING BRACKET REPLACEMENT (Sheet 1 of 2)
1-1/8 in. open end wrench
TOOLS:
1 in. combination box and open end wrench
Flat-tip screwdriver with 5/16 in. tip
SUPPLIES: Preformed packings (11591390) (2 required)
Remove control valve assemblies (page 21-37)
PRELIMINARY PROCEDURES:
Remove exterior release handle control assemblies
REMOVAL:
1.
Using 1-1/8 inch wrench, remove two nuts (A).
Remove mounting bracket (B) from vehicle.
2.
Using hands, remove preformed packings (C).
Throw packings away.
NOTE
When removing couplings (D) in
next step, bushing (E), washers
(F), and tubes (G) will remain
with couplings (D).
Using 1 inch wrench, remove couplings (D)
from mounting bracket (H).
Using 1-1/8 inch wrench, remove nuts (J)
from mounting bracket (H).
6.
Using hands, remove tubes (G) from couplings (D).
7.
Using screwdriver, remove washers (F) and bushings (E) from couplings (D).
Go on to Sheet 2
TA140915
