TM 9-2350-222-20-1-5
EXTERIOR RELEASE HANDLE BODY ASSEMBLY REPAIR (Sheet 1 of 1)
TOOLS: Ball peen hammer
Flat-tip screwdriver with 1/8 in. tip
Remove body assembly (page 21-7)
PRELIMINARY PROCEDURE:
1.
Using screwdriver, pry two drive screws (A) from body (B). Throw screws away.
3.
Replace defective parts as required.
ASSEMBLY:
1.
Place body (B) on flat surface.
2.
Position clip springs (C) onto body (B).
3.
Using hammer and punch, tap new drive screws (A) into body (B).
4.
Install body assembly (page 21-9).
End of Task
TA140914
