TM 9-2350-222-20-1-5
EXTERIOR RELEASE HANDLE CONTROL ASSEMBLY REPLACEMENT (Sheet 3 of 5)
Using 5/16 inch wrench, remove control
7.
housing (D) from bracket tube (H).
Remove control housing (D) from vehicle.
8.
INSTALLATION:
Install cable (A) through control housing (B).
1.
Install cable (A) through exterior body (C)
and into vehicle. Leave approximately 6
inches of cable (A) sticking out of body (C).
Install exterior release handle body assembly
3.
Inside driver's compartment, install control
4.
housing (B) onto cable (A) until approximately
10 inches of cable is visible at end with plastic.
Go on to Sheet 4
TA140907
