TM 9-2350-222-20-1-5
EXTERIOR RELEASE HANDLE CONTROL ASSEMBLY REPLACEMENT (Sheet 5 of 5)
10. Pull cables (A) toward fire extinguisher cylinders until tight.
NOTE
On early model perform steps 11, 12, 13 and 14. On late
model perform steps 13.1 through 14.
11. Install cables (A) through clamps (H).
12. Install four screws (J) into clamps (H).
13. Using hex head screw key, tighten screws (J) to secure clamps (H) on cables (A).
13.1. Install clamps (H) approximately 2 inches from end of shorter cable.
13.2. Install two screws (J) into clamps (H).
13.3. Using screwdriver, tighten screws (J) to secure clamps (H) on cables.
14. Install control valve assemblies (page 21-41).
TA253890
21-6
