TM 9-2350-222-20-1-5
HYDRAULIC PUMP VALVE AND ASSOCIATED LINES REPLACEMENT (Sheet 4 of 11)
Using allen wrench, remove two plugs (AP)
25.
from valve (U).
Using 3/4 inch wrench, remove four screws and
26.
Remove valve (U) from reservoir.
27.
Remove preformed packing (AR) from reservoir
28.
and throw away.
NOTE
Only do step 29 if plate (AT) is to
be replaced.
Using hammer and chisel, pry out four drive
29.
screws (AS) and remove plate (AT).
CAUTION
Heads of drive screws may be
Use
broken off during removal.
drill to drill out screw shafts. Be
drill through
not
to
careful
reservoir wall.
Holding elbows (AU) then (AV) in vise, and
30.
using 1-1/2 inch wrench on nuts (AW) and
(AX), remove tubes (AK) and (AN) from elbows.
Go on to Sheet 5
18-48