TM 9-2350-222-20-1-5
BULLDOZER BLADE ASSEMBLY REPLACEMENT (Sheet 2 of 11)
REMOVAL:
NOTE
If hydraulic system is not
operating, place selector control
valve in 'FLOAT' position.
1.
Attach hoisting device to lifting eyes on top
edge of moldboard (TM 9-2350-222-10).
2.
Raise moldboard to stowed position and lock
(TM 9-2350-222-10).
3.
Using 1-1/2 inch socket, remove screw and
lockwasher (A) from retaining cap (B) on outer
tilt arms (C). Throw lockwasher away.
Lower moldboard to ground (TM 9-2350-222-10).
4.
5.
Using 1-1/2 inch socket, remove screw and
lockwasher (D) from retaining cap (B). Throw
lockwasher away.
6.
Remove retaining cap (B).
Go on to Sheet 3
TA14111
